E-664: Rohde & Schwarz ESM 500A

E-664, VHF / UHF receiver Rohde & Schwarz ESM-500A; developed and produced by Rohde & Schwarz, Munich.

The VHF / UHF receiver ESM 500A from Rohde & Schwarz was used as standalone monitoring receiver with army designation E-664 and also as receiver of the P-736 VHF direction finding system.

• Principle: Superhet; IF 10,7 MHz
• Modes: A1, A3J, AM (A3), FM (F3), Puls
• Frequency range: 20 - 1000 MHz (A variant); 20 - 500 MHz (B variant)
• Digital frequency display: digital display 1 kHz
• Sensitivity: / Selectivity: 8 / 15 / 30 / 100 kHz

• Mains: 100 / 120 / 220 / 240 V AC
• Accumulator / batteries: the receiver can be operated from 19 - 30 V DC

• 483 x 132 x 506 mm, 18 kg (rack version)

• Remote receivers ESM 508K (20 - 87 MHz), ESM 517K (68 - 174 MHz), ESM 540K (220 - 450 MHz), from one power supple / control unit (GX500) up to eight remote receivers can be controlled.
• Panoramic display EZP

The ESM 500 VHF / UHF receiver in a 19” cabinet can be used as a monitoring receiver and replaced the ESM2 receiver in the P-736 VHF / UHF direction finder .

The receiver covers the entire VHF / UHF range from 20 - 1000 MHz , for SSB reception, the tuning step sizes can be switched down to 10 Hz.

The 99 memories can also be written externally via an IEC / IEEE bus or RS232C interface, a scan function allows to scan the memory channels - this functionality anticipates the possibilities found in a scanner receiver from the nineties.

The set is completely solid state.

The VHF / UHF receiving system ESM-500A made by Rohde & Schwarz was not only part of the P-736 VHF / UHF direction finding system, but it was also used separately as a monitoring receiver with the army designation E-664.

e-664-cplt.jpg

e-664-front-cplt.jpg

• Prospekt Rohde & Schwarz ESM-500A